This role can be based in either Glenrothes or Livingston working a hybrid working pattern Main Duties Working effectively within a multi-disciplined design team, adhering to company policies & procedures Analogue & Power Electronic product design Solving complex technical problems on new and existing products from our portfolio Electronic Schematic capture layout & simulation Design, commissioning, circuit debug and fault diagnosis through the project lifecycle Awareness and application of DFM&T (Design for Manufacture & Test) Document Verification and Qualification of products to industry and customer standards Configuration of product designs and their controlled change. Prepare technical document & reports Support internal & customer discussions, leading in your area of expertise. Essential Experience: Prior exposure and experience within Power Electronics/Design Good and demonstrable problem-solving skills with practical laboratory test, circuit & test measurement experience Good communicator able to engage technically within the company and to customers Desirable Experience with interfacing to RF circuitry and high-speed D/A/A/D conversion Experience with both RF and Power development Experience with programmable devices Experience in design of Switch Mode Power supplies, designs of Invertor and PFC design of full bridge, flyback, forward topologies or exposure to others Experience using the Mentor Graphics tool suite; xDX Designer, Constraints Editor, HyperLynx tools such as Signal Integrity & Power Analyser, System Vision simulation or equivalents would be advantageous. Knowledge of Firmware development, design and test using suitable toolsets (i.e. Xilinx Vivado, ModelSim). Proven analytical skills in circuit simulation (Matlab, LT Spice) Awareness and application of DFM&T (Design for Manufacture & Test) Experience of recognised standards MIL Std, IPS etc